by Willy - 7/12/05 6:29 AM
In Reply to: NEC Z1 case removal by phlame
I feel for ya, I tried some googling and hardly got anything worthwhile. As for the NEC support website, geeeezzz, what a waste.
By experience, find any screws on back and remove only if as a guess. Some covers are "tang(tongue)&grove" they match into each other and snap or press fit into one another. If a small slot is present, see if applying pressure with tool or fingers depresses enough to unsnap, work it. One end may screw down and then lift to reveal a tang&groove on corresponding side, lift and separate. Use common sense as once revealed, you see what logic went into putting it together. Also, a decal cover could be hiding a hidden screw, a warranty seal or such , depicts work done outside of warranty channels, proceed if no warranty.
Was this reply helpful? (0) (0)