Networking & wireless forum: Running a dedicated NIC for an hp printer with network conne

I have used separate or dedicated switches in this instance,what I learned was switches don't go bad often, but when they do it can be really taxing ( good descriptive) to trace it if you have more than one switch on a network. My idea is to keep it separate from the rest of the network. But I know it is not ideal nor is it something that is attempted often. That is what I am asking for a little help in configuring it.

Because it's so specific to the LAN, the OSes involved, the drivers, and tinkering with the print spooler this is something your IT staffer must accomplish on their own since they will have to support it.

I won't do this in our office because I don't allow high wire acts. That is, we want a LAN without a need to tinker or tweak. It must work.

As to your comment about troubleshooting the LAN, I've never found that to be taxing. But maybe it's because we have spare hubs and cables. I've run into sad situations where they don't have any spares and the boss is berating the IT staff for not being able to spot the bad part without swapping.
Bob

We are one of those companies that does not have a budget for spares, and I have been on the berating end of that situation. I am thinking the first thing I would have to have is a crossover cable. Would you agree with that?

The last NIC I installed (actually the last dozen) had AUTO MDX so I could use either straight or crossover cables.

Is your IT staff unaware of MDX and the move to AUTO MDX?
Bob

Most of our NIC are inexpensive 10/100/1000 cards or on board chipsets. I am limited in current schooling of modern network adapters. I used to setup two PC's with this type of direct cable connection.

Always check the specs. It's nice since I am down to just a pair of crossover cables in the IT room. And both are not in use. Just there if we need them.
Bob