Milk in Dell keyboard
by macewan_ - 2/23/09 1:47 PM
A friend of the family has spilled milk on her Dell laptop keyboard. Any suggestions other than not doing this in the future?
by: macewan_ February 23, 2009 1:47 PM PST
0 people like this thread
Total posts: 10 (Showing page 1 of 1)
If this friend immediately turned off the laptop
unplugged the power supply, removed the battery, etc., they could get lucky. I'd think the keyboard could be removed and cleaned carefully with water and rinsed with distilled, dried thoroughly and put back together. Anything that got under the keyboard would also need to be cleaned as best as is possible. It's really going to depend upon how much milk was spilled and exactly where it went.
The above advice is good.
If your friend isn't comfortable they can take it to a local shop. They should be able to do this for under a hundred bucks. If the Dell is still underwarranty, if there is any kind of WARRANTY problem (unrelated to the milk) Dell will refuse the repair regardless (which violates their own warranty).
The other thing is that by cleaning the keyboard you won't get those annoying sticky keys that make typing something annoying.
Turning off the laptop and hoping that nothing has fried in the electronics is key, not to mention that it shouldn't be turned back on until everything is completely dry. I've spilled coke on my laptop keyboard and have been able to clean it up and save it with not even a sticky key one!
I wish you the best of luck!
When you say you were able to clean it up, just a surface clean or did you take the keyboard apart?
Guess it could be worse. Don't they give away keyboards these days? Like $10 or so if she doesn't get a fancy one. Try tigerdirect, or do a Google search.
They don't give these away and they don't just attach in a few seconds. It also sits on top of the motherboard. Gravity becomes your worst enemy here.
I don't know about milk in a laptop(it will sour)but, we spilled red wine on a closed laptop and it ran into it from the logo on the top. (Packard Bell) Of course the warranty was long gone. The shop want too much money just to look at it, so...we were ready to throw it away. Once we were sure that it was dry we tried it. It made a horrible whistle when we turned it on. We kept it on in an area of the house that was cool, and protected in case of a fire. However, after a few weeks the laptop started working again. This was more than four years ago and the lap top is still working.
What you will need to do.
I found a dell laptop that this happened to a few years back. The computer would not boot so, I pulled it appart (not recomended unless you are a very carefull, inquizitive type).I found that the power ciruit board was fried by the milk shorting a few chips on the board. I found a website called impact computers which sold the exact part I was looking for (cost me around $80 au) which I instaled myself. Two years on, and it's still working.
Sorry I couldn't put the full website name up there as it could be construde as spamming.
Remove battery and then kybd.. Inspect area where kybd. was for any other spillage, clean if found. Use 90% rubbing alcohol and shop towels or use clean old t-shirt as rag. Once done, using liquid type soap place in warm water and wash the kybd. allow to soak and repeat until clean. After cleaning, remove and shake dry as much of access soapy water and then rinse in clean warm water. Repeat, until soap film is gone. Remove and shake until access water is gone. Rap kybd. against dry towel on all sides to help exit all water. Once done, place kybd. on sunny window or any heat source like heat vent(must be warm but not hot, avoid warpage) and allow to dry out. Make sure its dry!!!!!! Some water can be trapped in areas not easily inspected, so allow for as much time as necessary. Once done, return kybd. and test results. If it works, great if not, exit kybd. and dry out again for a longer period, then retest. if it fails again, buy replacement kybd. from some laptop used/repair source(google away). Unless, you have access to a cleaning vat, this will work. Its important to dry out kybd. as its sealed against some spillage but direct electronic contacts can be compromised until cleaned, yet be dry.
THIS IS ALL AT YOUR OWN RISK, otherwise pay for the service to be done or buy replacement.
Total posts: 10 (Showing page 1 of 1)