wis09abgn not working with WPA2
by miguellspinheiro - 4/21/10 4:29 PM
I have an LED TV UN40B7000 with an WIS09ABGN wireless adapter.
I have an DLINK DI-524 wireless router configured in G Mode and working now at 54 Mbps.
Both are configured with the last firmware (from Brazil support sites).
The problem is:
if I put both TV and router to use WEP, everything is OK and my TV works fine on @internet.
if I put both the router to use WPA2 (using WPA2 pre shared key and AES), the TV cannot connect.
The log on router shows the same error during one or two minutes. The log entries look like this:
Sunday April 18, 2010 12:43:31 Associated: 00-12-FB-2E-6F-44 st=0
Sunday April 18, 2010 12:43:35 Disassociated: 00-12-FB-2E-6F-44 because WPA retry failed 4
My notebook works fine using WPA2 with that wireless router.
yet, Here is some information about the router:
Beacon Interval 100 (msec, range: 1~65535, default: 100)
RTS Threshold 2432 (range: 256~2432, default: 2432)
Fragmentation 2346 (range: 256~2346, default: 2346, even number only)
DTIM Interval 3 (range: 1~255, default: 3)
Wireless Mode G (11 b/g Mixed G mode 11n mode 11 b/g/n Mixed)
TX Rates Auto (Mbps)
SSID broadcast Enable
Anyway, Is it possible to use WPA2? where I am wrong?