Community Newsletter: Q&A forum: Monitor Out of Range Whats is this?

Thanks for your reply.
I wish i could boot to safe mode, but the bad thing is that when i start the PC i cant get any display on my screen, the only thing i get is the warning message "monitor out of range"
i tried using another Monitor with the same PC it worked just fine. But when i try a different PC with the same monitor i still get the same message. Any help is welcomed.

Is it just me, or does anyone else see a problem with the monitor out-of-range even on POST? As was said before, the monitor cannot read the signal being sent to it (often a high resolution on a lower res monitor) and needs to be reset. In all my experience, though, I have never had a monitor not display the POST.

To Lino:
Does any other monitor work with the pc other than the original, and did the pc come with the monitor?

Dear,

Recently i am having a strange problem. computer starts but there is no display in the monitor. after few hours later when i power on the pc it starts with display. but when i restart there is no display again.sometimes it says out of range sometime not. first i have thought the problem might be in the monitor. then i have boutht a lcd monitor(benq). but few days later the problem reappears & still continuing. while starting the computer i do not hear any kind of beep code. i have also plugged vga cable to my built in graphics card, but the problem remains. my pc configuration is------

processor: intel pentium D 3.2GHz

hard disk: 320GB

RAM: 2 GB

Graphics card:nvidia pci express 256 MB(NVIDIA GeForce 7100 GS)

i am using vista 32 bit ultimate final.

I suppose you have a New System..is it the original monitor? did it work before?if so what was the change?did you replace some Hardware?well.if you can't go to safe mode..or any other move not helping...What about System recovery to Original settings..the Pc will tell you that the monitor will set automatically...what about?

Just had the same problem instead of choosing safe mode use the ENABLE VGA mode on the options when hitting F8 from here you can install the drivers and or make the relevant adjustments to your PC.