Computer help: Desktop Cable Management
Desktop Cable Management
by sebrenner - 4/14/04 1:02 PMHow do you deal with the mess of cable under your computer?
Re:Desktop Cable Management
by briancnet
- 4/14/04 2:09 PM
In reply to: Desktop Cable Management by sebrenner
I used to use a mountain of plastic tie wraps . . Then I found the little tiny velcro strips sold for just this purpose. They are much better, because they're reusable and aren't sharp like tie wraps when you cut off the excess.
Another thing I like a lot is using plastic rain gutters on the wall behind my desk as a raceway for cables. They're hidden from view and don't pile up on the floor where they keep you from *ever* vacuuming again!
Brian Cooley
CNET
AMP NETCONNECT is the answer
by jrearden - 12/23/04 7:18 AM In reply to: Re:Desktop Cable Management by briancnet
Techie clean-freaks unite!
I you haven't seen/heard about this before, check out the gizmos available as part of Tyco Electronic's AMP NETCONNECT Residential Cabling Systems: Media Convergence Centers, Cable Assemblies, Outlets and Accessories, OH MY!
http://www.ampnetconnect.com/products/displaysubcomponent.asp?comID=102
The PDF brochure at the bottom of this page is especially slick.
http://www.ampnetconnect.com/products/ProductDocumentation.asp?DTI=501&PG=567&SI=
Desktop Cable Management
by rmgordon - 12/12/05 1:30 PM In reply to: Re:Desktop Cable Management by briancnet
I have a lot of school districts as customers. Check out www.cable-safe.com. We used the Complete Cable Manager. Works great!
Re:Desktop Cable Management
by THEgIMPSHOP - 4/15/04 3:08 PM In reply to: Desktop Cable Management by sebrennerI'M REALLY HAPPY WITH A PRODUCT FROM "GE" CALLED "CABLE NEAT." IT'S A SLATE GRAY FLEXIBLE TUBING THAT ACCOMODATES (SP?) A DOZEN, OR MORE, WIRES. IT EVEN CONTAINS A WIRE NUMBERING (LABELING) SYSTEM. IT'S INEXPENSIVE, THO' I DON'T RECALL HOW MUCH IT COST. I'M A NEAT FREAK AND THIS STUFF IS GREAT ! HOPE THIS HELPS.
Re:Desktop Cable Management
by jdahs - 4/23/04 11:16 AM In reply to: Desktop Cable Management by sebrennerThis is a no-brianer: go wireless!
Short of that, I am also quite fond of velco-wraps, and even the occasional paper-towel roll attached to the back leg of my desk, through which I have run the various cables. This also works well for the entertainment system!
Re:Desktop Cable Management
by captainfepa - 4/23/04 11:49 AM In reply to: Desktop Cable Management by sebrennerRockler (woodworking) has what's essentially a mini-gutter (about 1"x2") with adhesive back (Wire Master Channel, #13665); it is expensive ($10/32" at their retail side) - they also have some other nice specialty items like that. Companies like Outwater Plastics often have the same stuff for lower prices, though I didn't see this item there at first glance. Usually, though, I drill holes near upper and lower edges of a 1x4 every 6 to 8 inches and insert 3 to 4" lengths of 3/8" dowel, rounding ends. Finally, staple Velcro cable ties (excess holiday variety at dollar stores 4-6/$1) every foot or two at the bottom edge of the rail, and use adhesive Velcro dots to match up at the top edge. Additional Velcro ties to the dowels where wires leave the 'tray'.
However, I have seen at a dollar store a knock-off 'tool holder' consisting of numerous semi-flexible plastic loops in a row several inches long, normally holding screwdriver shafts. I didn't think at the time, but these would work very well for organizing cables, spaced every 6 or 8 inches - I'll get a bunch next time I see them.
Re:Re:Desktop Cable Management
by jordegcam - 4/24/04 1:02 AM In reply to: Re:Desktop Cable Management by captainfepaDoes anyone have a photograph of all of these wonderful suggestions? I would appreciate this. Thank you!
Re:Re:Re:Desktop Cable Management
by captainfepa - 4/26/04 9:39 AM In reply to: Re:Re:Desktop Cable Management by jordegcamFirst, the Rockler item is pictured at: www.rockler.com/ecom7/product_details.cfm?sku=31&filter=13665 but as I expected it is much cheaper ($1.15/ft for 12') at Outwater, which I did find (with similar lidded channels) at:
www.outwater.com/computer_acc_page07.htm
I have no idea where I saw the multi-loop knock-off at some dollar store, but wish I could find it. It is similar to the much more expensive QuickClip items such as: www.studiodepot.com/store/index.cgi?cmd=view_item&parent=1008-1058-1231&id=8322 (usually sold as tool holders but also billed by its mfgr as a wire organizer; tool shafts or cables snug in between the semi-rigid loops, not through them).
I have no photos of my own tray/rails.
Re:Desktop Cable Management
by dhookom - 4/23/04 11:56 AM In reply to: Desktop Cable Management by sebrennerMy workstation setup has a main work surface and a wide shelf above where I place my printer, scanner, laptop docking station etc. I didn't like the cords hanging down in sight. To support the shelf, I bought two 2" dia. x 24" long galvanized pipe and four matching flanges. These parts are readily available at most hardware stores. I assembled and painted the flanges and pipe and then mounted them between the desktop and shelf as the only support. I then drilled 2" holes in the desktop and shelf at the ends of the pipe. I could then run lots of USB, power, KVM, and other cables through the pipe where they are out of sight. I think the total cost was less than $20.
Re:Re:Desktop Cable Management
by Lammy - 4/23/04 12:24 PM In reply to: Re:Desktop Cable Management by dhookomI prefer a large open surface to work at. So the main portion of "control central" for me has no shelves, hutches or other obstructions aside form the monitor on it. Make about a 1" hole where ever you need cables to come through the surface or sides. Then using furniture tacks secure those velcro cable management strips about every four inches. Neat. Out of site, and easily changeable. I've even tacked some in a circle so I could coil and secure lengths of longer cable up and out of the way.
Re:Desktop Cable Management
by rlgates - 4/23/04 2:43 PM In reply to: Desktop Cable Management by sebrennerPanduit makes a cable tray. It comes in a variety of sizes and I'm pretty sure colors. It has slots in the sides to pass the cables and it has a snap on top. This stuff is indispensable and works well even in a clean room environment. I found mine at the local Eoff distributer but I'm sure it's probably available elsewhere and it's not that expensive. It's a good solution and it adapt's very well should your setup change.
Here's a link to the product line:
http://www.panduit.com/products/browse2.asp?classlevel=763
Re:Desktop Cable Management
by actionj - 4/23/04 2:49 PM In reply to: Desktop Cable Management by sebrennerI have two power strips with remote power switches. I mounted the power strips under the desk outlets pointing down. Now when I plug something in, the cord naturally hangs up and out of the way. The remote power switches mean I don't have to stand on my head to power up/down the whole system. I have two of these power strips so I can put the displays and printers on one (which isn't on a UPS) and power them up/down seperately from the CPUs.
Re:Desktop Cable Management
by jairak - 4/23/04 11:49 PM In reply to: Desktop Cable Management by sebrennerI wind excess cable lengths in circular rolls of about 3 inches in diameter and tie them up with the plastic coated wire that wrap the cables from the factory. These then hang out of sight behind the computer desk and keyboard drawer and well off the floor. All my AC cords are plugged in to a fused outlet extension strip plugged into the UPC which is plugged to an AC wall outlet about 20 centimetres above the top of my computer desk. All out of sight leaving nothing hanging that could brought down by errant housekeepers, pets, brooms or vacume cleaners.
Re: Desktop Cable Management
by bobcurtin - 6/15/04 5:14 PM In reply to: Desktop Cable Management by sebrennerI built a 11ft long large wooden desk with a surface that is 4 ft deep and is placed hard up against a wall. The plank of wood on the surface of the desktop closest to the wall is not fixed to the desk and has a number of half circles along its inner edge cut into it for cables to pass through from underneath . Supporting the full length of the back of the desk is a 1 ft deep cupboard. On the top shelf of that cupboard (immediately under the removeable board) is located
- a Cable modem and 8 port switch
- 4 power boards
- a back up hard drive
- all cables
The majority of the cable clutter is thus hidden in the top shelf of the cupboard. If someone turns up with their laptop I lift the board plug them in and pull out a network cable and they are on line.
After all that hard work I bought a wireless base station and now I hardly ever use the desk!!!
| Forum legend: | |
 |
Locked thread |
 |
Moderator |
|
CNET staff |
 |
Samsung staff |
 |
Norton Authorized Support team |
 |
AVG staff |
 |
Windows Outreach team |
 |
Dell staff |
 |
Intel staff |
